Hi all,I have the following doublesided vPC topology wfwSay, vlan 10 traffic passes through NX9K3, instead of using the port channel, it goes through the vPC peerlink, and through NX9K4. STP is blocking the port channel, and designating the peerlink,...
Thank you so much Christopher. I've tested it with various vPC-failure scenarios and it works like a charm. Peer-Link is "designated fwd" and the vPC toward the spines is in "Root fwd" state. Just one last thing if you don't mind, should the command ...
Hello again,Did you intentionally leave NX9K3&4 without a vpc configuration on the port channels? Because right now, you have configured 1 VPC going to two different switches, and then on those two switches, you have configured a normal protchannel. ...
Thank you for your reply. I think I have chosen a wrong title. It is intentional that The spines (NX9K1&2) have their own vpc domain. In this example, i have simplified the diagram, where in reality, i have 2 spines, and 10 leaf switches, each 2 form...
