Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i've done the following config on my Cisco 92348-GC switch:nex1-9000(config)# snmp-server protocol enablenex1-9000(config)# snmp-server location MYLOCALnex1-9000(config)# snmp-server engineID local AA:BB:CC:DD:EE:FFnex1-9000(config)# snmp-serve...
Hello,i am not sure if i understand accesssing Layer-2 devices from devices correctly. I have a Cisco Switch (i guess it does not matter which one) . See attached file.There is an INT GI0/1 where i have a computer connected . This interface is config...
Hello,i am not sure if i understand accesssing Layer-2 devices from devices correctly. I have a Cisco Switch (i guess it does not matter which one) .There is an INT GI0/1 where i have a computer connected . This interface is configured as an access p...
Hello Cisco community, i've got a weird problem. I have a server "A" connected to Gig2/0/16 as an access port (VLAN28) to my Catalyst C9300 switch (Two stacked switches). I can ping the device from within the switch. The switch has an SVI configured ...
Hello Cisco community, i've got a weird problem. I have a server "A" connected to Gig2/0/18 as an access port (VLAN28) to my Catalyst C9300 switch. I can ping the device from the switch. The switch has an SVI configured for this vlan 28.I also have m...
Ok. I've resolved this issue. The switch needed a reboot. It did not accepted all my commands obviously. After rebooting and configuring it from scratch it worked.
Hi,thank for your hints. But i've already recreated the user several times. And in fact i see it like you. Something is missing in the users config. This can also be seen in the "show snmp user" output:But then again...what to do with the missing enc...
Hi, here is the IP Config once again. There is not much more to config. VLAN tagging is "off". There is no traceroute on the host itself. Only ping. And the host can ping the switch (It's gateway): tracert from my PC:
@Georg Pauwen It's an ILO HP Interface. There is no vlan configured for this interface PLUS this interface worked just a week ago with an older cisco switch.
