Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a simple topology where two inside VLANS have HSRP Gateways needs to access Internet through ASA. I can ping the inside Interface of ASA 5506 (Packet Tracer Simulator) from PC/Laptop but cant able to ping the Internet Router. Can any one share...
I have two AS 100 and a transit AS 200. I have received the route on AS100-1 generated from AS100 router by using as-in command but they are not pinging. Please have a look at the attached topology.
I just performing a basic NTP Lab on GNS3. I have three routers connected with a Switch on Vlan 1... I perform below commands. The clients clock are not synched 1- NTP SERVER: Command #1#ntp maste Command #2 ntp source fa 0/0 Command 3 ...
I am working on Packet Tracer Toplogy where i have three routers on right where i configure static routig and i have three routers on left where ospf area 0 is configured. I redistribute static network into ospf with the command Router(config-router...
I have modified a little in the topology and add a L3 Switch before ASA. I can now ping ASA internal interface from desktop computer but cant be able to reach the internet. ASA config attached.
Thanks for your reply.I am untouch from ASA quite long.I would be glad if you please enlighten me a bit about NAT (Static &Dynamic) operation in ASA in and exact commands to make it work.Also fixup protocol icmp is not working in ASA Packet Tracer.[i...
I add the below command and R5 able to ping R8.Router(config-router)#redistribute connected subnets But the loopback of R4 which is advertise into OSPF is now seen as OE2 routes on R8 because of this command. How to overcome it?
