Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a 5545-x with software version 9.1(1), and i am having problem with NAT and PAT translations.whenever i use an ip in a NAT rule i cannot use that ip in a PAT rule. I can accross this information on cisco.com" If you enable extended PAT for a d...
I recently upgraded our VPN remote access clients to AnyConnect, now everybody in the organization can access the VPN. I was wondering is there is a way to block everybody and give access to who we want to give access to.Also, I like to know how to s...
I am pretty new to this discussion, but i have a problem that i need help with. i have an ESX server in my network and i am having problem with associating a vmware host/server to a certain vlan. this is the problem:we recently moved our data center ...
How does one assign a network management traffic (rip, BPDUs, CDP, etc.) to a VLAN? I know to assign a computer to a VLAN, you simply add the port in that VLAN, but what I do not understand is adding network traffic to VLAN when they do not have port...
we are using LDAP for authentication.no, i do not want the users to connect to the ASA at all. is this posible? i want only those who we allow to connect and not the entire organization as it is now.
can you explain a little what you mean about your first sentence ("why you use all trunk with native vlan and do not use interface in access mode for that vlan?")
I am not sure i understand your question? all of the blade ports are trunk with native vlans because each blade is cappable of having more than one vlan.are you talking about the blade port/slot or the main switch port???
