Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a topology consisting of 3 routers like the ones shown in the image below. There is MINIMAL configuration on these devices.
R1:
int g0/0
ip address 71.46.94.1 255.255.255.252
no shutdown
ip route 71.46.94.6 255.255.255.255 71.46...
Hi Greg & Jaderson,
I've done this now in both VIRL and GNS3 both using IOSv images, and of course, just like taking a car to the mechanic shop, as soon as I go to configure the devices again and take screenshots to send to you, it starts working....
I've also found before when receiving the error below that also in the log is the a message about LACP not being enabled on the remote port. In this case please check to see if using channel-group X mode desirable or channel-group X mode on would fix...
