Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having an issue with internal and external clients. When we have the nat ip configured on the controller we cannot connect internal ap's at all. When we take the nat ip out it works fine. We are on code 7.0.220. I have tried the following comman...
Hello,I am having a hard time getting my cert to work right on the ACS for PEAP. I have acs 4.2 se. I have a 3rd party .pem. certificate I have loaded it into the install acs cert as the cert file and private key. I have also loaded into the authori...
We have clients that will randomly disconnect from an AP and then cannot connect again until the AP is rebooted. We have unselected exclusions and they are not going into an excluded clients list. Any ideas?
Here is what I have selected under Global Authentication SetupPEAP Allow Posture ValidationPEAP session timeout (minutes) 120Enable Fast ReconnectEAP-TLS Allow EAP-TLS Certificate CN ComparisonUse Outer IdentityLEAP allow Leap (for Airone...
I think I have gotten that part to work now because it lets me enable EAP. However on my wireless clientit gives an error of Could not authenticate. Int he log it says authentication failedduring SSL handshake
Looks like since the upgrade we still have a few that are seeing this problem with the atherso 5004x cards. Has anyone else experienced any problems since the upgrade?
