Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there folks - it's been a while since i've been on here so i'm hoping the level of technical expertise is still upto the previous high levels. I have a problem with a C887VA-K9 that i've been scratching my head over for some time now. The router ...
Hi Folks, We have a pair of WiSM modules in our Core switches and a pair of 5508's in our DMZ. We can successfully tunnel clients to the Anchor controllers in the DMZ when there's no AAA specified, however, when I add AAA servers for Authentication ...
Hi All, I'm fairly new to ASA management so would appreciate some feedback here. I have a single firewall at a remote site that is quickly becoming more mission ciritical. To remove the single point of failure I have a second identical unit I inte...
Hi all,I'm fairly new to the Cisco WLAN architecture and am curious what siginificance the 'Profile Name' associated to an SSID has locally on the WLC? We have 8 SSIDs all with unique profile names and, I believe, the profile name is only locally si...
Jon,Honestly, I read your response and thought to myself "Pah, this guy's mad!"..It's almost too simple... too obvious a difference between the subnets... Then I read this.. Q. Does Cisco IOS NAT support ACLs with a "log" keyword? A. When you config...
I was considering using the NVI NAT method rather than traditional NAT but i'm not using any VRFs here so can't really see the benefit of doing so. Also, the router is running the following code : c800-universalk9-mz.SPA.153-3.M3
Thanks for the quick response Stephen. I read the following info on the Wireless Guest Access FAQ that seems to contradict what you're saying.. Q. In an Anchor - Foreign WLC scenario, which WLC sends out the RADIUS accounting? A. In this scenario...
Hi Aaron, I am experiencing the same issue when using a WISM2 module in a 6500 chassis and WLC software 7.0.116.0. I have recently (today) upgraded a redundant controller in the failover pair to 7.2.110.0 and reassociated the relevant AP's to this u...
