Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I have an envorinment with 18 APs wich are mostly 1242AG and one 1142 AG. I have a 2125 Wireless Lan controller servicing the network at this time. I have set up the 2504 wireless controller on a test network along with a spare 1242AG AP....
Hello, I have 18 APs that have been working more or less properly. I have room for 7 more on this controller wich leaves me plenty of room to grow at this point in time. My question is if I were to need to upgrade my access points to something that d...
Hello, I am looking to configure a wired and wireless guest network. I have industrial barcode scanners that connect to one SSID and then there is the business network on the office SSID (no vlan seperation for these devices just different SSIDs). Th...
Hello, I have a 2960 switch connected to another. The I need to verify that vlan0010 on one switch is forwarding tagged traffic between the other switch it is hooked up to through the Gi0/1 port. How do I verify this? I have a server that's multihome...
Thanks for the update and the answer! So per the article you sent I could just have it on the same lan and have them join the new controller. I have configured all the AP's with static addresses. This is a very tedious process for me since my busines...
So I have almost the same issue here. I have a 2125 controller and am running 7.0.98.0. I have 1141 and 1242 access points. Upgrading the controller software I understand cannot go past 7.x from these posts. Is there any particular documentation I ca...
Yes a reflective nightmare to say the least but I have been doing well so far. I just need to cover the area here in the picture. You should see inside! Omni directionals are working for inside ok I guess but it could be better. I do not know that I ...
Roughly 15-20 feet with some applications requiring panels for outdoor wide beam converage. Basically the antenna model I have listed is covering an area where there are a lot of steel coils in a warehouse. The APs are mounted either on a pole or cei...
Thank youn so much for the information. I appreciate the discussion. Do you have any comments on my selection of antenna? I was wondering if there was something else I should be using? A professional site survey was done before I started my job here ...
