Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have 6 NICs with 2 x 1gig and 4 x 10gig. Wanted to use for the following workload. What are the good options?1. Service Cosole2. vMotion3. NFS (to store VMs)4 VM Network (Virtual Machine network)Thanks in advance.Chandra
Hi, I am building UCS system UC applications. I have two 5108 chassis with 3 B200 M2 blade in each Chassis. I completed configuration and want to do 'Production Readiness Test’ on UCS. When power down Fabric Interconnect-A (Primary), all my ESX hosts...
Hi Robert, thank you very much, this would help me a lot.I am bit confused on the limitation "ONLY one VLAN can be allowed on on Uplink Port Profile"Port Profile 1 - Service Console, VLAN 10Port Profile 2 - vMotion, VLAN 20can't I create a single Upl...
Hi,I am in the same situation, I have 4 x 10Gig and 2 x 1Gig on my ESX servers. I wanted to use these for the below network traffic on Cisco nexus 1010.My thought would be......2 x 1gig -------> Service Console + vMotion2 x 10 Gig ------> NFS (Ip st...
Thanks Manish, Not sure whats happening, when I did the first test plugging out FI-A 's power. I lost network connectivity for about 5mins. Then all my VMs were with the error "EXT3-FS.........Journal has aborted". Then we have to reboot all VMs to ...
Hi Manish thanks for the reply.We have disks on SAN, no vc, as we are built this environment for Cisco UC applications.After full day of Sunday’s work, I found some issue with upstream topology or configuration.We have two 3750 upstream switches one ...
Hi Manish,I just going through this thread for finding solution to the issue I am facing on my new UCS setup.I am using palo card (M81KR), when I powered down the Fabric interconnect-A to test failover, I am losing connectivity to all my ESX hosts f...
