Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a SG 300-20 small business switch and I would like to restrict bandwidth by gateway ip address but not by physical port or LAG. On the web interface, I can only do bw limiting per port or lag. I want to do bandwidth limiting by the IP addresse...
I got the SG 300-20 small business L2/L3 switch. I've read through the 325 page pdf manual and I still can't figure out how to do what I need to do. Here is my setup using example ips...switch layout-------------------isp -> p1 (vlan 1)workstations -...
I don't think that will work. My switch is in Layer 3 mode (I need the layer 3 routing features) and the next line under that quote says..."QoS policers are not supported when the switch is in Layer 3 mode."
