Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a question about the Mobility softkey on my phone. I have SNR reach setup in my UC560 so any calls to my DID or Ext ring my cell phone. If I do answer these calls from my desk phone, I am able to choose Mobility and then "send call to mobil...
'm attempting to factory reset a UC560 and running into all kinds of issues...I've tried the below steps on both a Win7 Laptop and WinXP VM (firewall off and other NICs disabled) all running CCA 2.1 (2).From the Maintenance -> Restart/Reset menu, I'...
I'm new to the UC560 world and am trying to get my NFR box setup on my network without removing my current firewall. I've gone through the attached guide and removed firewall and NAT configs. Right now I have the WAN port configured for an IP on my...
ahh, thx I see that now. I entered the commands into IOS and everything looked to work, but IP hasn't changed and I can still login with my credentials!!!Calling support....
I doubled checked and unfortunately for me I am already running CCA 2.2 (2), not sure where I got 2.1 from in my post...I've tried to go through the CLI reset again and keep getting stuck at the copy command, tried both flash and tftp. What am I m...
Makes sense on the VLANs, thanks. So I am fine having only the WAN port on my UC plugged up to my network?Can't seem to get the phones to find the Voice VLAN DHCP server running from the UC560 and I was worried it was being broadcast over a differen...
