Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllAll sites in the attached diagram are physically in different towns. I plan to have a vpn network between all sites using the ISR's. But on SP premises thinking to put E1 to Ethernet converters . Is it doable and is it worth it ?tnx
Antonin,Here is the output you've asked for:Switch#sh int gig 0/1GigabitEthernet0/1 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is 0064.4018.e619 (bia 0064.4018.e619) MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec...
Team,First of all thank you all for your responses. Problem is clear, but how to solve it. I have some more outputs now. Here is the ouput of the "sh controllers ethernet-controller " command :Switch#sh int fa0/1FastEthernet0/1 is up, line protocol i...
I will talk to SP then, is there any E1- to Ethernet Convert you can recommend ?I have mux Topgate(http://eltex.nsk.ru/sites/default/files/MAKOM-MX_ToPGate.pdf), it should work as Ethernet over E1 as well, right ?
Just to be clear, in the attached design all blue objects are on Service Provider premises.Easiest solution will be to put 1921's on each blue circle place where I planned to put converters, but was looking at more cost-effective solution first. I ca...
