Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have an alert in Cisco Prime about a "PD Removed", when I remove a PoE Cisco Phone un other interface, and mention a non-existent port on a switch that I'm administrating. This is the alert:Critical SW-TEST May 7, 2019 9:23:22 AM PET Interfa...
Hi Community, We recently adquired a Cisco Prime's Solutions, it send us an email according security threats but also, send us a email about Interface down/up:Message: Port 'GigabitEthernet1/0/3' (Description: 'Not available') is down on device '172....
Hi Shaun,- The first command is to set the port in access mode, if you don't use it, you depends on the mode dynamic and the other side.- The second command is to set the vlan on the port.Regards,
Hi @beginner1, As @luis_cordova said, that router has a NAT preconfigure, I've tried to disable it but I couldn't, Instead of that, use an Access Point to access to your wireless devices. I've donde the configuration on your file that I attached, PC2...
Hi @MarioLieb, your switch had found 3 differents MAC Address and that's why the port maybe got blocked, you can validate that using the next command:show interfaces status | i errandshow port-security interface [INTERFACE] If your problem got a solu...
Hi,You can validate on which port your computer is, desconnecting it and looking which port turned down, when you have the port try changing the cable or using other port for the computer, if the problem persist maybe the port has a problem, but if n...
