Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I'm trying to configure cisco 3560 for basic 802.1x with ISE 2.6. I have a single PC attached to gigabitEthernet 0/1 but I dont see any pop up on PC to enter username and password. Not sure dot1x is supported on this switch but all the command...
Hi,We are testing ISE and so far we've successfully tried authentication using username and password but now we want to test certificate based authentication. Will self signed certificates be ok for dot1x authentication between a windows client and I...
Hi There,My ISE version is 2.4.I'm able to get hits for web redirect URL profile for web authentication. BUTHow do I create an Authorization rule for endpoints that have already authenticated through the portal.I am putting the endpoints in an endpoi...
Hello There,Previously we had 2.4 version of the ISE and the redirect URL we used to receive for guests on our switch was below: Redirect URL : https://my-company.loc:8443/portal/gateway?client_mac=ClientMacValue&portal=27041710-2e58-11e9-98fb-005056...
Hello, Is there any keepalive mechanism between the switch and ISE. I need to know if there is a way which can enable the switch to know if ISE server is online and available at any particular time.The idea is that lets suppose we try to authenticate...
Thank you so much Rob, that first one worked out very well, though some commands syntax was a little different but worked pretty well in the end. Thanks again.
Yes we are only testing and I dont have access to PKI certs at the moment so thats why I asked if I could give it a run with the 509 type certs.And allow me to say this it was a pure joy reading your post, best post one could read to start their day,...
Well it shows DACL for me also when I choose Cisco and vendor but I need DACL to show for a non Cisco device. If any can tell if thats even possible within the Cisco ISE's design would be much apreciated, thanks.%23%23- Please type your reply above t...
