About MarkTheGreat

MarkTheGreat · 05-13-2020

Greetings All,We're looking for a relay that will pull in using the ring signal from an "FXS" port on a Cisco router.Router: ISR4331 (with "FXS nim" card).Buzzer or horn: 120Vac.Port has been configured (FXS) to ring but I'm not able to measure ring ...

MarkTheGreat · 05-13-2020

Thank you Jamie,We had found Viking and are currently awaiting a reply.Thanks,MG

MarkTheGreat · 05-13-2020

Roger - FYI -Per Cisco documentation:"Ringing VoltagesThe industry standard for PBX and Key Systems requires that the ring detection circuit be able to detect a ringing signal as low as 40Vrms. This voltage takes into account the effects of load and ...

MarkTheGreat · 05-13-2020

Thanks for the reply Roger.I am working with our electrician. Due to the increase in VoIP technology replacing old phone systems, we were both betting that Cisco did not offersuch a relay board, but are both certain a third party somewhere makes a de...

MarkTheGreat · 01-08-2019

With the advent of Cisco's Webex, we tend to use the VoIP for audio and for video we use a laptop Chromecasting toa big-screen TV. We would like to take the audio from the 8831 and send it (wired) up to two wall-mounted speakers on either side ofthe...

Member Since	‎01-08-2019 07:46 AM
Date Last Visited	‎05-17-2020 01:01 PM
Posts	5

User Statistics

User Activity

Sounding a Buzzer or Horn Using Router's FXS Port -

Re: Sounding a Buzzer or Horn Using Router's FXS Port -

Re: Sounding a Buzzer or Horn Using Router's FXS Port -

Re: Sounding a Buzzer or Horn Using Router's FXS Port -

Re: Hi Joseph,