I have the attached high level SD-WAN network.There are 3 locations. Location A,B & C . All are interconnected using SD-WAN.In location 3, I have connected L3 switch behind the SD-WAN device. To this switch packet capturing server is connected.My req...

I am using cEdge SD-WAN ISR4331-DNA.I want to know in case this SD-WAN cEdge crashes and not booting, how  should I recover it with the new device. What are the things I need to consider and what are the steps I need to do to replace the faulty devic...

I have Cisco ISR 4451. I has interface Gi0/0/0I want to set the port to 1000/full.Is the below command command sufficient ?interface GigabitEthernet0/0/0speed 1000no negotiation autoOr should i also need to add "duplex full"Let me know.

I have the below command.The switch port  type is P2p. It is not P2p edge. Because of that this port is part of STP topollogy change. Which means whenever the switch port goes up/down STP topology change notifications are sent.This port server is con...

I have come across the below command.no spanning-tree optimize bpdu transmissionWhat does the above command used for & its use cases ?