The datasheet for the DN3-HW-APL lists a reduced core count compared to the DN2 version, but it does not mention RAM or disk specs. Does the DN3-HW-APL have reduced specs for the memory and disks as well?
If you don't need the "how and why" you can find complete templates in the summary section at the bottom of this post.The problemCatalyst Center onboarding templates are somewhat limited in functionality. They don’t allow for interactive commands suc...
The release-notes for CML 2.7 beta has been released, but there is no mention of when the regular release will happen. Is there any timeline for when we can expect 2.7 to enter general availability?
I am working on automating lab setup with Terraform and have hit a wall with DNAC-VA configuration. I have figured out how to apply basic configuration to the DNAC-VA using cloud-init on VMware(imitating the launcher). But this leaves something to be...
After quite a lot of troubleshooting I found that the latest IOSvL2 image fails(throws CPUException and resets) when I bring up L3 port-channels with multiple subinterfaces. Where can I report bugs like this?
This is not how the RTU licenses are intended to be used and I highly suspect that it will not be well received by Cisco. Invest in the appropriate licenses instead of trying to find a gray-area solution to get around it. If you go this way I recomme...
I usually do this by setting called-station-id to "ap-name-ssid" and matching based on AP name. This is easier to understand for colleagues working with the ISE deployment and the AP name prefix is usually equally if not more suited to match the spec...
I have c8000v nodes running fine on the same versions in my lab. I did however have some similar issues(can't remember if it was the exact same process) when I overprovisioned CPU on an older virtualisation host. Do you get the same issues when runni...