Hi! I have a Cisco C1111-8PW router, which has a built-in WLC and a built-in Wireless AP. Currently, they are configured for FlexConnect, but I am having some issues setting up some VLANs on the WLC and the APs and using the VLANs, so I figured i...
I am not sure what I did wrong here, but I had this working, and now it doesn't work. I have setup two VLANs on a WLC that's built-in to my router, the C1111-8PW, VLAN1 and VLAN40. VLAN1 is on the 10.0.0.0 / 24 network, VLAN40 is on the 10.0.40....
Hello,I noticed since I added a Cisco AP 1832i to my network, we are having some issues connecting to various external sites. For example, I go to google, and about every 4th site I try to go to will time out. I refresh the page, I can go just fi...
Hi!I am reading about private-VLANs and I think they might be the solution to my current issue. I currently have two VLANs, and two wireless SSIDs. VLAN1 (10.0.0.0 / 24) is mapped to the Company SSID, VLAN40 (10.0.40.0 / 24) is mapped to the Comp...
Hi! I have a Cisco C1111-8PW running 16.06.05 and I am trying to setup an extra VLAN for the first time. My current setup is like this:
Static Public IP on GigabitEthernet 0/0/1
VLAN1 on network 10.0.0.0 / 24
VLAN40 on network 10.0.40.0 / 24The...
Thank you!
I also believe it's a configuration issue. I am uploading a hand-drawn picture of my network topology. The WLC and first AP are built into the router. I have not figured out how to disable FlexConnect on the WLC, nor have I figured out how...
@Flavio Miranda,Thank you for the reply. Currently, because I cannot access any GUIs at all, I must do everything from the console ports. I did not do anything with the SSIDs, I didn't realize I had to. From your example, I have now issues the ...
I think the WLC and router had some sort of caching going on somewheres, because no matter how I configure the router or the WLC interfaces, I cannot seem to reach the router or the outside world. I'm converting the AP to local mode (or trying).I b...
A bit of progress. If I set the management interface to VLAN10 and then on the built-in AP, I tag the packets with the VLAN ID 10, then the WLC can reach the outside world, but the AP fails to join the WLC with a message saying:
Layer 3 discovery r...
So I reset the WLC config to the default. Then I reconfigured just the very basics.I set the IP address of the management interface to 10.0.0.2 with the subnet mask of 255.255.255.0.I executed these commands after doing the basic auto-configure stu...