Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Not sure on the best way to do this. Here is my setup:Cisco 1841 Software (C1841-ADVIPSERVICESK9-M), Version 15.1(2)T1, RELEASE SOFTWARE (fc1)Cisco Internal IP:192.168.X.254Cisco External IP 64.X.X.5 (NAT)Netopia DSL Router:Internal IP: 192.168.X.253...
I get this in the syslog on every boot:Sep 23 11:48:25 192.168.210.118 PGSK: chkcfwd in Idle key list is not definedSep 23 11:48:25 192.168.210.118 PGSK: chkcfwd in Idle key list is not definedSep 23 11:48:25 192.168.210.118 PGSK: chkdnd in Idle key ...
I am using a 3 tiered provision setup. On the root of my TFTP I have spa504G.cfg:<?xml version="1.0" encoding="UTF-8" standalone="yes"?><flat-profile> <Profile_Rule ua="na">/CiscoVOIP/$PN.xml</Profile_Rule> <Syslog_Server ua="na">192.168.21...
I am looking for a good source of info on methods to troubleshoot zone based firewalls. My main problem is getting dropped packets logged and knowing what rule is dropping them. Presently only some get logged and fewer still give a reason that I can ...
I have a basic IPSec tunnel between a 1841 (site a) and a non-cisco (site b) router. All appears okay but the only way I can ping site b from the 1841 is to source the private interface. How can I make is so this is permanent? I would like syslog and...
That seemed to do the trick. I could swear I tried that when troubleshooting this, but I tried it one more time on your suggestion and after a factory reset it loaded all 3 files without a hitch.thanksGreg
agreed. I was preparing my switch to dump the traffic to my desktop so I could sniff it and establish the culprit. I did find numerous other examples where other users had the same issue. Seems there might be a bug in some versions when netflow is so...
UPDATEI tried Ricks suggestion and created a NAT pool. It is working much better. The download speed is pretty much right on but upload is very low. I am going to compare results by doing a test connection via fa0/1 and compare results.I am working o...
