Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two WLC 5508 running 8.0x firmware, and they are in the same mobility group.The second WLC was only installed recently.
the management IP is in 192.168.x.x/24 for both WLC. Both have Mgmt via Wireless turned on.
when i try accessing the first...
Hi allI have a question to ask.If a laptop with a static IP roams from one AP to another, and both AP are in different WLC , different AP group with different vlan interfaces, can it still roam? Are there any additional configuration needed on the WL...
Nope No ACL, i took it all out on the dynamic interface and management interface, both sides.
Yes AP associate to WLC2, i can access WLC2 via mgmt.
I even bring down the mobility group to test if i can manage both, and i still can't.
Disabling/enabli...
I got this from cisco 4400 Controller, however does this applies in the 5508 controller?
http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/69561-wlc-faq.html
Q. With the Management via Wireless feature enabled on...
Thanks for the link
If i have multiple WLC with same interfaces and subnet and SSID , they are in same mobility group, when i set static ip and roam around without the static ip tunneling, am i right to say there should still be connectivity?
Because...
