Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I configured a VPN Site to Site with an ASA 5570 ( Headquarter) and a router 881 ( Branch office) , LAN networks are 192.165.0.x and 10.213.21.x , the problem is that I don't have connectivity between these LAN networks only between peers however ...
Hi,I want to know if is possible configure VPN Site to Site within LAN between two ASA using two differents subnets without use WAN link neither internet and if is possible how can I configure it?Thanks for your helpAna Maria
Hi,I want to know if is possible configure a VPN router model RV082 for following two functions at the same time or if only is possible configure one of two:1. Access to internet from LAN2. Access by VPN Client from remote networkMy question because ...
Hi, I want to know what is the procedure for password recovery IDSM-2 and if this procedure needs to restart switch core or only module. I have been reading and I have understood that is necesary download an image WS-SVC-IDSM2-K9-a-6.0-password-recov...
Hi,I have problems with access to WS-SVC-IDSM-2 because when I try to access by CLI with command session slot 10 processor 1 appears following message:The default escape character is Ctrl-^, then x.You can also type 'exit' at the remote prompt to end...
Hi,I attached router configuration but I don't have ASA configuration however in ASA is configured ACLs for outgoing and incoming traffic, a tunnel group, group policy, ipsec rules and static routes, if you need I can send a topology to please collab...
Hi Paul,Yes I was checking that link but this is not clear because don't explain commands for upgrade image and if is necessary to restart core switch or only module for perform password recovery.Thanks for your help
Hi,I tested with an admin account and it functions correctly but I need find a document where is expressed that account must have administrator privileges.Thanks for your help
Hi,Thanks for your help, Do you know which commands would be the correct to copy ISO base image and patch to appliance CSACS 1121 from TFTP or FTP, or if you know other form to copy these images to appliance.
