About ts015

ts015 · 01-22-2019

Hi All, I have 2 Cisco routers connected via DTE-DCE cable for simulating T1 connection but both serial ports do not seem to be working. Could someone please help check my configuration below. I am trying to ping computer B at the Ethernet port of ro...

ts015 · 01-22-2019

Hi Alan Ng'ethe,OK, let me upload it here.

ts015 · 01-22-2019

Hi Alan Ng'ethe,Do you know what else do I need to configure the routers so that I can ping the Ethernet port in switch B from computer A?Computer A: 192.168.1.101Ethernet@router A: 192.168.1.100Serial@router A: 128.0.1.10Serial@router B: 128.0.1.20E...

ts015 · 01-22-2019

Hi Alan Ng'ethe,Yes, I just found out that my cable had some problems. Everything works after changing the cable.....However, do you know if clock rate is required when T1 connection is deployed.Thank you very much.

ts015 · 01-22-2019

Hi Alan Ng'ethe,Thanks for your help. The serial port shows down in status after following your configuration, any other clue?Thank you.

Member Since	‎01-22-2019 07:36 AM
Date Last Visited	‎02-17-2019 07:03 PM
Posts	5

User Statistics

User Activity

Bridging Over a Wide Area Network using dte dce cable

Re: Bridging Over a Wide Area Network using dte dce cable

Re: Bridging Over a Wide Area Network using dte dce cable

Re: Bridging Over a Wide Area Network using dte dce cable

Re: Bridging Over a Wide Area Network using dte dce cable