Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem with a MDS 9124 which has a duplex mismatch with a WS-C2960G-24. When setting both port to auto/auto the WS-C2960G-24 displays: Full-duplex, 100Mb/s while the MDS displays BW 100 Mbps half Duplex. This issue results in a duplex mi...
Hi,At a customer site I have installed an UC540 with one dualline isdn2 trunk and a SIP trunk configured. Incoming phonecalls are handled correctly. In my config outgoing phonecalls depend on the priority of the dial-peer (sip or pstn) whether the ph...
Our wlc can't communicate with any host on vlan Z (subnet 192.168.1.0/24). The wlc itself is in a different vlan. All communication to other vlans works just fine. I've temporarly disabled the access-lists for vlan Z, without success. A host in the ...
Yes the upgrade was performed. After the upgrade I was able to set the speed and duplex settings. So this action cleared the duplex mismatch messages.Kind regards,Dimitry
Thanks for your reply,I found the caveat at http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/nx-os/release/notes/19964_08.htmlSo that probably means a sw upgrade.Kind regards,Dimitry
Hi,Yes I did but this is the outcome:MDS1(config-if)# switchport duplex fullMDS1# sh run int mgmt 0interface mgmt0 ip address 192.168.0.1 255.255.255.0The MDS is unreachable from the network for a while after submitting the "switchport duplex full" ...
Thanks for the response.Does this mean that in the next release of CME v8.1 where multiple SIP trunks are supported I have to configure outgoing calls with corlists similar as you discribed in your reply? Or will there be support for that in CCA?Kind...
Yes I am routing to that vlan as I am routing to other vlans. I have tried adding a route to the subnet but I am receiving a message saying, Gateway need to be on service port subnet. According to the manual it is not possible to route traffic to the...
