Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a c9300 in use as a router. We have inter vlan routing and source based policy based routing.When we try to go to addresses that do not have a route in place for, the mgmt page for the c9300 comes up. I have not been able to find anything rel...
Morning everyone,We have a Cisco ISR2921 running BGP for our public subnet with 2 ISPs attached to it. We are planning to replace with device with a new C9300. I have copied all the bgp config and routes over and setup the interface in the same man...
Working on a project to consolidate multiple routers for our various networks into 1 Catalyst switch stack, we are using catalyst 9300-24-T-As The different networks we have need to go out different firewalls towards the internet, need to be able to ...
I am not very familiar with configuring Dot1x authentication, and without more of you config cant parse it out. Dot1x usually uses a radius server to provide the port based authentication. Looks like you should have a group called "radius" that ha...
