Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello gentle people,I'm labbing a vrf-lite setup and I feel the config is good. Per the topology, CORP works but PROD does not. The networks behind the core neighbour are pingable for CORP but not PROD. Here's the config for R1 & R2 : -R1#show runBui...
Hello all, I'm setting up a VPN with a 3rd party who have suggested the use of 172.16.8.0/26 as the encryption domain on my side of the tunnel (happy to do this to avoid wasting public IP's). There side of the encryption domain is 70.0.0.x/27. I am p...
Hi all, Hopefully you can help me out. I'm trying to configure a DMVPN phase 1 Hub to Spoke connection (only mGRE and NHRP). On the hub my tunnel 0 interface is up/down and i'm unsure why. I've triple checked the tunnel config. (NBMA and tunnel IP's ...
Francisco, Thanks for the prompt reply. So something like this :- access-list internet_1_cryptomap line 1 extended permit 172.16.8.0 255.255.255.192 70.0.0.0 255.255.255.224nat (inside,outside) source static 192.168.1.0 172.16.8.0 destination static ...
Just a quick update to finish off. Turns out it was a GNS3 issue. Deleted the hub router and re-applied config to a new hub using a different ios. Everything now working as intended. Bloody GNS3. Appreciate the help all around.
Added the topology earlier in the thread.Already did p2p and worked (specifying a single destination at both hub and spoke). I'm trying out Phase 1 but it looks as though it could be a gns3 issue. I'll give Phase 2 a go and see how that works out. Ap...
Nice one for the suggestions. I'll give them a go. I'm beginning to think it is a weird gns3 issue. I've had a good few second opinions and the tunnel configuration, by all accounts, looks good.
