Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.. I have a few refurbished ws-c3850-24P switches and one of the has ACLs and I do not know how to remove them properly, please help. Thank you! - Bill (see below). I did erase the startup-config and reloaded, but these entries did not go away. i...
I have configured my cisco 3850 swtich for L3 Routing and have followed many online resources from Cisco about proper configuration, but am not able to get the inter-vlan routing to work. I have checked all of my commands several times and going thr...
Hi I have just configured a 3850 switch for ip routing and have been through the configuration many times, but still no routing is taking place. I have enable ip routing and setup several vlans with IP address (different subnets) added several trunk...
Hi Paul.. thanks for your reply.. I believe you are correct and I have been searching for the way to just "disable" autoquos, but have not found it simple.. is there a command to just Disable it, or is it complicated? Thanks for your help.. I've bee...
@Joseph W. Doherty wrote: PS:If you want disable redirects, build a dedicated transit network, need additional help, etc., feel free to ask. I, and/or others, will try to help.Thank you for your post.. I do have some work to do here as I want to get...
@andrew.butterworth wrote:So your windows servers default gateway is the Internet router and you have now added a static route on the Internet router for the networks routed by the Catalyst 3850. Your workaround will work but it is suboptimal.Hi Andy...
@Joseph W. Doherty wrote:" I was originally trying this route 172.16.0.0 255.255.255.0 172.16.0.254, thinking that it would cover ALL of the SVI's, but for some reason this never worked."Or try 172.16.0.0 255.255.0.0 172.16.0.254Head Slap!! - Yes.. t...
