Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, can someone help me out please.I like to use my new switch like to get rid of the interface naming convention that it has default, I think due to stack settings:To configure a 1G ethernet switch port I have to do now:conf ttester(config)#int G...
WOW! that was quick Thank you Enes for responding on my question. And yes it's sounds logic, I only thought that I did something wrong. I just have to get used to this naming convention. Thanks again for your clear explanation and yes I already used ...
Ok that is good news, I tested now also with the new loaded image and indeed no problems found, works perfect now.Be aware the upload can take a while, and also the reload.Greetings Christian.
Hello All,I discover today that Cisco put now the right image on the link.https://software.cisco.com/download/home/286288151/type/282463182/I verified the image with the sha512 checksum and indeed image is exact the same as the image of the SG350.I w...
Hello All,Today i received an answer on my case I logged for this problem see below the answer from CiscoAnswerI just tested and you should be able to use the larger SG350 image and install on 250.Normally this is always the same image and the issue ...
