Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've configured the VMM Domain, AEP and installed the AVE but it fails to obtain a TEP address even though everything appears to be configured correctly?
cisco-ave:~$ ip address show dev kni05: kni0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdis...
Hi,
Is there any documentation on how you add the "4th" APIC in a DR scenario.
Our environment is set-up for ACI Multi-pod with 2 APICS in Primary DC and 1 APIC in Secondary DC.
Primary DC (Controller ID/No Controllers/POD ID):
APIC01 - 1/3/1
APIC0...
I have hosts with multiple uplinks that connect to separate L2 disjointed networks.
Each AVS instance will have uplinks that connect to the different networks, is it possible to install multiple AVS switches on the same host?
Thanks
I have hosts with multiple uplinks that connect to L2 disjointed networks. Is it possible to install multiple AVS switches on the same host. Each AVS instance will have uplinks that connect to the different networks.Thanks
Hi
After rebooting our spine chassis we are able to ssh onto the management IP but the line card is showing offline and the APIC is unable to see the Spine.
The line card is showing a flash sts light that is orange.
Please could you assist?
Versio...
Can these instructions be used to integrate OKTA and ISE for Device Administration?
I am working on using MFA for device administration for when we access our network devices.
Thanks
Also seeing this issue not just on Avaya 9650 but all Avaya models that we have. We dont just see this for failed devices, we see random successfully authenticated devices have this issue. Mainly when the users place the laptop in Hibernate mode. ...
I can connect to the leafs and spines from solarwinds but cannot connect to the APIC itself.I also did not need to create contracts for the leaf/spines.
Have attempted to add a contract but the APICs are still not seen from Solarwinds. I suspect I've...
I have console connectivity to the new isolated ACI Leaf (not connected to APICs) so I can logon to it.
I also have a mgmt. connection cabled but there is no IP Address used or configured on the ACI leaf.
Is it possible to logon to the ACI leaf direc...
