Cisco 891-K9 router, very basic config, minimal firewall in place.I keep getting warnings in the log:Dropping TCP Segment:xxxx is out-of-order... Reason:TCP reassembly queue overflow....I have increased the size of the ooo queue etc. as follows (incr...

The basic setup... Newly installed redundant ISP, thus setting up the 891 with dual WAN, Using PfR to load balance between the two. Did initial config through CCP (not express), but I am familiar with the basics of IOS CLI (not used to the new zone b...

The basic setup... Newly installed redundant ISP, thus setting up the 891 with dual WAN, Using PfR to load balance between the two. Did initial config through CCP (not express), but I am familiar with the basics of IOS CLI (not used to the new zone b...

Just setting up and testing a Cisco 891-K9 router. Used CCP for basic setup, figure I'll tweak any settings needed later.For the firewall, I chose the default "medium" security setting in CCP, then added some holes (already setup in NAT) for outside ...