Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I read in many IT websites that Cisco has confirmed that it will end development of its Application Control Engine (ACE) load-balancer products and it will not develop further generations of its ACE.By the way, is it a correct information? D...
Dear all,I'm doing to configure an ACE with bridged mode to load balance incoming traffic to 3 TMG servers following this network diagram:The system design require to have 4 IP address on the same NIC, and 3 VIP for each pool of the IP as presented i...
Dear all,I configured an ACE in bridged mode (inside vlan: 2012, outside vlan: 2021) and I apply the L4 policy on the 2 VLAN interface to loadbalance HTTP incoming request (Virtual IP: 172.22.22.130).interface vlan 2112 bridge-group 1 access-group ...
Dear all,I'm using to attach a layer 3 switch to vPC domain 1 (followin the network diagram). I buit a layer 3 Port Channel on my catalyst switch and i have to root the trafic to the next hope 192.168.0.1.Is it necessary to use HSRP on the Nexus 7010...
Dear all,I'm doing with a collapsed VDC-core/VDC-agg model on the same chassis with 2 Redundant Cisco Nexus 7010 and a pair of Cisco 6509 used as a Service Chassis without VSS. Each VDC Core have redundant link to 2 PE based on Cisco 7606.After re...
Hi Daniel,I have 52 server working correctly and the only problem that I have is with these 3 server. I wanna ask if there is any problem to have rserver having the same mac address when we are using ACE in bridged mode? Just for you information, whe...
Well, my question is very simple, it seems for sure that having 3 rserver having the same mac address is causing a problem with ACE on bridged mode and blocking the traffic betweend the server and the firewall.Is there any solution for that?Thanks.
This is for help the show arp result. I see that the four IP address of each server have the same mac address but only the first IP is LEARNED. Is it normal?================================================================================IP ADDRESS ...
Hi Mark,You are right, and i have done this since long time and the problem was solved. I don't like also specifying speed or duplex mode but it was the solution for my problem.Regards,Abdelaziz
Olivier,I configure the nat pool and apply the SNAT policy under vlan 2012 and it's working. This is the config to be added to the standard configuration in bridged mode:-------------------------class-map match-any SNAT 2 match source-address 172.22...
