Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have one internet router with two ISPs, (Serial 0/0/0 connected to ISP-1 and Serial 0/0/1 connected to ISP-2).I configured IP SLA 10 and 20 as follows:ip sla 10 icmp-echo 8.8.8.8 source-interface serial0/0/0 frequency 6 timeout 6000ip sla sc...
Hi All,We have one Cisco ASR router connected to two ISPs (Gi 1/0/1 and Gi 1/1/1), and connected to one Firewall from the LAN side (Gi 1/0/23), and 20 VLANs connected to the Firewall LAN interface, 10 VLANs can access Internet from the first ISP link...
Hi All, We have 4 sites, each site has its DHCP server, we changed that to be one DHCP server at the HQ office and all other sites will be assigned TCP/IP configuration from that one DHCP server. On each site, we configured DHCP Relay "ip-helper add...
Hi All, Is there a way to show the IPSec Site-to-Site VPN logs from Cisco ASA using ASDM? I created a IPSec VPN using Cisco ASA but the VPN tunnel is not UP, i want to see the logs via ASDM indicating why the VPN tunnel is not established, cannot fin...
Hi all, When i try to install the FirePOWER software on Cisco ASA 5516-X and i issue the following command: ASASFR-boot> system install ftp://192.168.2.4/asasfr-sys-6.2.2-81.pkg It gives the following:Verifying 110Upgrade aborted When i ping the addr...
Hi All,The issue has been resolved.a) First i changed the IP SLA to use source ip address instead of source interface.b) Second, we make agreement with each ISP to make a BGP filter to DENY the source ip used by the other ISP, so this will achieve th...
>> Are you getting full routes from each ISPS or just default route?Default Route only.The issue is that i need to track the ISP network and in case any kind of failure INSIDE the ISP, traffic is re-routed to the other ISP, that's why i use PBR with ...
Ok but what about routing based on source IP/subnet?i need to let half of the traffic to go through ISP-1 and half of the traffic to go through ISP-2, and in case of failure of one ISP, traffic is re-routed to the other one.
>> If you want to restrict amount of download bandwidth provided to your VLANs, that generally pretty easy to accomplish via policing or possibly shaping.Could you please tell me how to do the configuration for the downstream traffic, and then on whi...
- you like to do this when both the links up and running ?Yes- this need more clarity (not full means you want to limit to 90% of link ?I mean can we use something like traffic shaping so traffic does not exceeds the 34M, and if so, traffic should be...
