Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So here is the deal, I have a server on switch A where port 3 is monitoring traffic for most of the ports on switch A. However I have other users on switch B that needs to have port 3 on switch A monitor as well. Is this possible? I have been reading...
Does the Catalyst 3560 support the RTP priorty command? We are implementing a voice recording solution on the network and it requires RTP to be enabled.WS-C3560-48PSVersion ID:V05Software:12.2(35)SE5 (IPBASE)When i log into my switch I will go IP ? a...
Hello Everyone,So I am tasked to enable port mirroring so some voice recording software can function properly. Here is what the requirements are but its simply not making any sense to me. I am hoping someone here who knows port mirroring can look at ...
Hi guys,I'm new to networking and was looking for some assistance. First off im using packet tracer to diagram my senario as I will be receiving my equipment next week to deploy. Hardware to be used:1. 2 catalyst 3560 switches2. all connect to a soni...
Abzal,Here is what I have going on:Switch A rspan vlan:VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Fa0/1, Fa0/2, F...
Abzal,Looks like its correct then? I wonder why its not receiving any traffic then on the server for fa0/3? When I had the below command in before these changes i was at least getting results on switch ASwitch A:monitor session 1 source interface fas...
Ok with those commands in place I am not getting traffic on the port when I look at the incoming outgoing traffic on the server, so its not capturing data.
Here are the configs i have in place now, Do these seem right to either of you?Switch A:Session 2---------Type : Remote Destination SessionSource RSPAN VLAN : 10Destination Ports : Fa0/3 Encapsulation : Native ...
Mahmoodmkl and Abzal,On swtich A the command monitor session 2 source interface remote vlan 10 does not work.what did work was monitor session 2 source remote vlan 10 will this suffice?Also why different session numbers? and if the destination port i...
