Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We have a project in which we are using 34 Cisco SG200-18's each with a MGBLX1 (LC Single Mode Fiber) SFP mini-GBIC.All the fiber's come back to one building where we must "bridge" all 34 fiber connections. What hardware should be used to acco...
Hi leoloahoo/all,Is there any sort of Cisco or otherwise Fiber Patch Panel (series of two etc) that could be stacked to unify the 32 connections to then just tap into a Catalyst with one fiber patch cable?I do apologize, as I am still unclear how mul...
Thank you Tom,Turns out we may not need to provide the "patch panel" as we will likely use an existing one provided by the primary telecom provider and just have a patch over fiber to our core switch.Based on your recommendation, I am looking at usin...
Thanks again for the reply Tom,The network utilizing these switches will not be segmenting into any variety of VLAN's, this will essentially be one single LAN all the way up to the CORE switch, after which it may link to a larger overall IT infrastru...
Thanks for the response Thomas,So from a patch panel would the core switch be an L2 Switch?Would multiple patch panels such as the Blackbox JPM380A work with the TP-Link TL-SG5412F with LC GBIC as the "Core Switch"?
