Do the ASA support GRE tunnels specifically for DMVPN tunnels?
I read somewhere that maybe the newest ASA firmware, 9.9x-something, might support it....
do you know if Cisco has finally added this on the ASA if so, can you provide a link?
thank...
Folks, couple concerns regarding this new switch we recently purchased...
-Do you upgrade the firmware here the same way as you do with the lower end catalyst switches?
-if we will only use this for a single network, in our case for iSCS traffic,...
Guys, I need some clarification here. I have already asked couple TAC guys but they either did not know the answer right away or they wanted to send me to another team who might answer it...I have a single router. One LAN, one WAN. It is an 800 serie...
Hi guys,What is the best practices when deploying the IOS Firewall feature on routers, especially on the 800 series routers?I know that a router will never be a true firewall but those features are there to make them simulate...Usually what I do is t...
I have 2 routers doing GLBP. The virtual IP is given to the workstations as their Default Gateway.When a packet hits the default gateway, it'll go to RTR-A. Then the second packet request will go to RTR-B. This is all good via GLBP.The question is, i...
Folks, thank you for this confirmation. I think I now know what I might have been reading and that is perhaps the new ASA support to GRE interfaces but not necessarily DMVPN.
Because of that, I jumped on this and purchased an ASA 5508-X for a new b...
Hi RJI,
Thank you for the quick response.
Because of the fact that VTI/Tunnel Interfaces are now supported on ASA, that still makes the ASA not support DMVPN?
So perhaps the info I got meant GRE tunnels? Because you need tunnel interfaces for G...
I read somewhere few days ago that it does.... at least the forums/articles I was reading mentioned tunnel interfaces and the fact that ASA with the newer releases now were finally able to support tunnel with Amazon.... This is the part I remember a ...
Thank you guys for the confirmation. I sort of suspected this and this is why I asked you guys... I read the release notes and this is a different ball game... it is NOT the same as upgrading a catalyst 2950!!
Hi Sean,
Thank you for the answer. I wanted to confirm this because, yes, the switch will be isolated completely.
So essentially what is done is just connect the devices to the ports and that is it, correct?.. without setting up any VLANs....
T...