Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Friends..
We have configured our ASA firewall to allow Trace Route to reach outside destinations (over internet), as per configuration attached.
But, we are unable to get information of hops in ISP path during Tracing Route to reach destination, ...
Hi All,I am using Cisco 2960X-48FPS-L switch running with IOS image "C2960X-UNIVERSALK9-M" version "15.2(2)E6" and using IP Services license to enable L3 features.We have two Routers connected to this switch using Redundant uplinks for High availabil...
Hi, I am unable to access ASA using SSH from my PC and can able to access ASA using SSH from other PC's, using the same IP address i have tried on my PC. We have upgraded our ASA with version 9.6.3.8 from version 9.6.3.1 and we are running the config...
Hi, Could someone please suggest me, the configuration to monitor Latency thersholds to our VoIP destination using SLA monitors, for ISP failover. I am using ASA - 5516x with two ISP providers connected on Firewall. We are routing default route on I...
Hi, We have configured failover (Active/Standby) between our 2 ASA firewalls using the configuration giving below. We have tested the failover by power down our Primary ASA (ASA-1) firewall and our Secondary ASA (ASA-2) is become Active. But, the se...
Hi Mark,
Sorry, i am not able to see all the commands under "ip sla ?" as listed in your reply.
I am able to see only below commands in my switch,
switch(config)# ip sla ?
key-chain Use MD5 Authentication for IP SLAs Control Messages ...
Hi Jumora, Thanks for your responce and suggetions to my query.we have observed, no errors on Firewall interfaces which the ISP and LAN network has connected.Also, we are not facing the latency issue everytime and it is hitting during the traffic con...
Hi Karsten, When we do "no failover active" on Primary Firewall, the Secondary Firewall is able to start forwarding the traffic within sec's.But, if we powerdown the Primary Firewall (Active) without "no failover active" command, Secondary Firewall c...
