Hi all,
how to read the level of a ciaco 891at the Wanport.SFP out ???
router#sh int gigabitEthernet 8GigabitEthernet8 is up, line protocol is up Hardware is PQ3_TSEC, address is XXX) MTU 1500 bytes, BW 1024 Kbit/sec, DLY 10 usec, reliability ...
The command "Transceiver "is not supported . i still have the problem .
it must be possible to read the values !
with a 4300 it goes ....Router #sh hw-module subslot 0/0 transceiver 0 status (GigabitEthernet0/0/0)
The Transceiver in slot 0 subslo...
Hi Seb Rupik ,
sorry but ..Cisco 891 does not know this command look ....
Router_1#sh interfaces gigabitEthernet 8 ? accounting Show interface accounting counters Show interface counters crb Show interface routing/bridging ...