Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to remotely access a server in packet tracer, like you would with a router or switch via telnet or ssh? Examples of servers as in mail, DHCP, DNS or web servers? I'm being asked in one of my projects to allow only certain staff member...
I'm using Packet Tracer 7 for my assignment to build a network with working application layer services, whilst everything in every LAN is functional I'm having an issue with the webcam and motion detector. They've been connected to a registration ser...
Hi everyone, I just setup my own network and configured the routes between the serial cables statically, I tried sending an email from the Curzon PC to the Millenium Point PC in a different LAN but both the PCs are unable to the servers in the Josep...
I've been given a set of IP addresses and subnet masks for each LAN and I want to connect these altogether. However I've also been given a WAN IP network address and WAN subnet mark to connect particular LANs together: ^ required to connect these LA...
Thank you for your help, I managed to figure out what I did wrong. By accident I didn't add the IP address or subnet mask to the actual SMTP server by going to Services then EMAIL. I even had a POP3 authentication error which I strangely managed to ...
I'm not sure how you got these answers: 1 to 2: 186.48.192.0 255.255.255.02 to 4: 186.48.193.0 255.255.255.04 to 3: 186.48.194.0 255.255.255.0 I'm new to Cisco and only in my first year at university so I haven't covered a lot in networking yet, cou...
