Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is anyone aware if there is a separate MIB which returns the resource usages per connect by polling the Admin context only? Specifically the bandwidth resource usage per context. We don't have a management address in each context but have a require...
We've upgrade a 7206VXR from Version 12.3(14)T7 IP PLUS Feature Set to 15.2-4.M5 SP Services. Since the upgrade we're no longer getting policy maps applied to the Virtual access interfaces. The policy is applied via a "cisco-avpair="ip:sub-policy-...
Hi,I'm currently configuring a new ISDN circuit which is to be user for dial in access, which I can't get to stay up. It constantly cycles between the following (Sh isdn status) AWAITING_ESTABLISHMENT > TEI_ASSIGNED and will every minute or 2 change...
Hi, I'm trying to configure a LAN-to-LAN VPN on a Cisco VPN 3020, I need to configure it so that the access to the local and remote networks is restricted to 3389 only when Phase 2 is negotiated, e.g Source (Local network) 10.1.1.1 Dest (Remote Netwo...
Hi Alex,
Thanks for the response. I had seen that document but when we query those MIB's we only get a response for the "default" context not per context resource usage. We have 4710's btw.
Cheers
Thanks for the reply, I had previously enabled "network-clock-select 1 E1 0/0/0", it doens't solve the issue. I don't have the option to apply the command "isdn tei-negotiation first-call" router(config-if)#int serial 0/0/0:15router(config-if)#isdn ...
Apologies forgot to addE1 0/0/0 is up. Applique type is Channelized E1 - balanced Description: xxxxxxxxx No alarms detected. alarm-trigger is not set Version info FPGA Rev: 08121917, FPGA Type: PRK1 Framing is CRC4, Line Code is HDB3, Clock Sou...
I've tried applying the filter and the VPN still won't come up, it fails at phase two still, with the port blocking removed at the remote end it works ok. Anyone know of any cisco docs which advise if this is supported or not?
