Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had to perform a factory reset and upgraded switch to latest version - 15.2(7)E14 - but the web GUI header displays: {{productOwner}} {{platform}} {{deviceDescription}}{{version}}I'm not sure if there is a fix. I've tried modifying the headerCtrl.j...
I'm looking for a basic router that will take our WAN side layer 3 IP and NAT to our public LAN block of IP addresses on our firewall. I realize this isn't much to go on, but it is a rather simple setup. There are approximately 80 users on a 100Mbp...
I used the upgrade option from the Web GUI on this one. Upgrading using the CLI has produced zero problems on the other switches. However, performing the upgrade using the CLI -even after a factory reset- doesn't appear to fix this issue.Edit: I just...
