Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I have 3 E1 circuits connected from 7613 Router to 3640. I?m trying to configure load-balance to share these circuits (by OSPF), but, I have no success. Look the sh ip route and ospf below:sh ip route vrf vrf_name ospfO E2 1.1.1.1 [110/20] via ...
HiHave an AS5400 with modem cards and E1 ports, configured for dial backup with callback. Sometimes the callback doesn't complete, and in the debug output we receive the message "no interface available". Soon after in the debug, there is an incoming...
Richard,Me too. I sending to appreciate the commands that you suggest (except the ping, cause this interfaces are in use). Look the output packets and rate to see the difference between 3 E1s.Regards
Thanks Jorge!This solution is possible only on 3640 (in this case), but on 7613 is not possible!Per-packet feature not appear available on 76XX routers.Anybody have any idea?
