About jasonviar

jasonviar · 08-05-2008

I was working with a co-worker who was seeing FTP choke the B channel when a remote router was on ISDN. Normally we use rate-limit on the frame-relay PVC's, which works great, but when I configured it on the BRI0/0/0 interface, I was not seeing hits ...

jasonviar · 12-13-2010

OK, didn't know if there was a way to see what the BW is for the class-default. Sounds like no, other than 25% of the bandwidth statement. Thanks for the quick response.

jasonviar · 12-13-2010

Is there a command that shows the allocated bandwidth for the class-default?"show policy-map interface xx" will show for the other classes where it has been explicitly defined, but nothing mentioned for class-default.I am referring to a situation whe...

jasonviar · 08-05-2008

Thanks again. I will look into it, but unsure why the command takes on the interface but does not work. Thanks - Jason

jasonviar · 08-05-2008

We do use that for EIGRP as well, since the frame pvc's are set as having higher bandwidth. My issue is not with the 255/255, more that the rate-limit is not working during congestion time.

jasonviar · 08-05-2008

At this point we are back on the frame-relay connection, so show output wouldn't be helpful. Here's the interface config.interface BRI0/0/0 description Circuit ID and Carrier bandwidth 30 ip address x.x.x.x y.y.y.y ip accounting output-packets ip nat...

Member Since	‎04-22-2008 11:56 AM
Date Last Visited	‎11-01-2017 05:24 PM
Posts	9

User Statistics

User Activity

Rate-Limit BRI

Re: QoS question about class-default traffic

Re: QoS question about class-default traffic

Re: Rate-Limit BRI

Re: Rate-Limit BRI

Re: Rate-Limit BRI