About tlowry

tlowry · 04-29-2009

We recently added a controller and upgraded our access points to LWAPP. I previously used the wpa handshake timeout command on our autonomous access points to fix connectivity issues with some Intermec hand-held devices and some wireless printers. ...

tlowry · 04-08-2011

The AirCheck from Fluke Networks is a very good tool to have around for wireless testing and troubleshooting.

tlowry · 11-10-2010

I upgraded to 7.x code on WCS and WLC4404. No issues on those 2 pieces but the 2700 Location Appliance stopped working. Cisco TAC provided Location Appliance software version 6.0.103.0 to fix the problem.

tlowry · 10-18-2010

I had the exact same problem after upgrading WCS and WLC4404 to version 7and 2710 to version 6.0.102.0. TAC sent software version 6.0.103.0 for the 2700 Location Appliance (along with a disclaimer) and it fixed the problem. No word yet on an offici...

tlowry · 05-05-2009

I have used an evaluation version of a program called DWGSeePro. It works well for converting Autocad files to JPG that can then be loaded into the WCS software. The program can be found here.http://www.autodwg.com/

Member Since	‎12-20-2008 05:07 PM
Date Last Visited	‎08-08-2018 12:02 AM
Posts	7

User Statistics

User Activity

dot11 wpa handshake timeout on WLC4404

Re: Wireless signal tester

Re: CleanAir Technology and Version 7 Code

Re: Clients Not Detected on MSE (2710 Location Appliance)

Re: AutoCAD DWG to jpg