Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I wanted to upgrade my WiFi at home from two 2802i running on Mobility Express to 802.1AX AP's running on eWLC. As availabiltity for 9120's is quite poor here in Germany I bought two 9115AXI-E and converted them to eWLC. On day 0 where you ini...
Hello, the issue has been fixed in 17.6.1, but if you are running an older version you can enter the following commands on CLI to permanently set the country code: enableconf tap dot11 5ghz shutdownap dot11 24ghz shutdownap country PTno ap dot11 5ghz...
Hello, you will need to convert it from lightweight to Mobility Express if it is running a lightweight image. There is no autonomous mode for Wave 2 AP's, check: https://community.cisco.com/t5/wireless/coverting-aironet-2800-series-access-points-from...
Don't know about the one from Solarwinds but Synology uses OpenTFTP. You need to SSH into the NAS, then:sudo vi /etc/opentftp.iniPress ESCInsert "blksize=8192" into "[TFTP-OPTIONS]" sectionPress ESC againSave and quit with ":wq!"/usr/syno/sbin/synose...
IOS XE uses "ip tftp blocksize 8192" by default to speed up file transfers, might be there are incompatibilties with the TFTP server. Normal TFTP blocksize is 512. So perhaps lowering the blocksize to a value of 1456 or even 512 fixes the issue. Open...
Hi rrudling, after deletion of "GB" via GUI my startup config only showed "wireless country DE", wireless country supported "GB" and "DE" like yours. Cannot remember the other outputs. But the "GB" country code was active again after a controller reb...
