About AlexanderJesse

AlexanderJesse · 04-05-2011

Hello!I am using 2 WAP4410N in bridge mode with WPA2 Security.The bridge seems to be stable but i get poor transfer rates.Distance between devices ~ 8m - nothing between.Wireless networkmode: N-Only, Channel: Auto, Channel Bandwitdh: 40MHz (also trie...

AlexanderJesse · 05-17-2011

i had this 3 AP config one year ago but i noticed problems with moving clients and some appson our smartphones.thats why i wanted WDS or Repeaters because in this config there shouldnt be a disconnect.

AlexanderJesse · 05-17-2011

Status Update:if i use as described 1 AP and 2 WDS Repeater i get no IP (DHCP Server on LAN) if i connect over a repeater.If i am close to the AP i get an IP.now i tried to setup 3 APs with same SSID but different Channels.if i move between the floor...

AlexanderJesse · 05-17-2011

why not set all three up as ap?if i do that - i have to use 3 different SSIDs - right?if i use the same SSID - will that work? can i walk through without disconnection?i think i will disconnect at one AP and connect to the other.

AlexanderJesse · 05-16-2011

Hello!I received FW 2.0.4.1_T6 today.Installation without problems.Now i want to configure this resolution:1 device as AP @ First Floor - connected by PoE to my network1 device as Repeater @ 2nd Floor - connted by PoE to my network1 device as Repeate...

AlexanderJesse · 05-16-2011

Try this - worked for me :-)You can contact me at "emoyers at cisco dot com"ThanksEric MoyersCisco Network Support Engineer1-866-606-1866

Member Since	‎04-04-2011 07:31 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	10
Total Helpful Votes Received	5

User Statistics

User Activity

WAP4410N poor bridge performance

Re: WAP4410N stops responding very often

Re: WAP4410N stops responding very often

Re: WAP4410N stops responding very often

Re: WAP4410N stops responding very often

Re: WAP4410N stops responding very often