Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I copied the running config from a production stack 3850 ( 2 switches ) to another 3850 stack on the test bench :-1- The config did not apply the 2nd switch on test stack. - should I manually edit each g2/0/X interfaces ?2- The IP routes did not appl...
Hi we are in the process of upgrading the firmware on our Catalyst 3850-48T - I have the below options from cisco firmware download.Catalyst 3850-48T-E SwitchCatalyst 3850-48T-L SwitchCatalyst 3850-48T-S Switchwhat does E , L , S Switch mean ?is it t...
Hi All , I am in the testing phase of migrating to a 9300. So far I have done the below.3850 running 16.3.6 and 9300 updated 17.09.04aI have copied the start-up config to the 9300 - all looks ok apart from the usual ip routes , some interfaces not ...
Hi All , I have 2 separate networks each with Core switches , say network 10 and network 192 and wish to connect the 2 networks and also the relevant vlans with 2 cables running from one to the other for a little bit of resilience but it isn't that p...
Hi All , Have been at it for a long time ! The connection wont establish Attched is the config applied on the ASA which is generated on Azure*Configuration of the ASA -:Hardware: ASA5516, 8192 MB RAM, CPU Atom C2000 series 2416 MHz, 1 CPU (8 cores)...
Thanks for the reply - I will check the stack numbering- so is there any reason why it still says gateway of last resort not set even after issuing the ip route 0.0.0.0 0.0.0.0 <firewall ip > ?
Hi yes exact same model - firmware of the production is older copied from old switch to and applied by running command from usb to startup config and reloading.
Update - Upgraded one Standalone switch - All worked well The Show Platform command shows the full model number if that help anyone while downloading the firmware.So just as a precaution - I have copied the config from the production sw to the spare...
Thanks for all the replies ! If I have a spare couple of 3850 , Can I upgrade those and swap them in ? Provided I copy all the running config on to the new switches. The current set up is running VTP server - would that cause any issues ?
