Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have an ASA5508-X and my ISP has provisioned our modem for multihoming. Could someone please explain the steps necessary to have the second IP on the public interface and how I can route all traffic from that WAN IP to an internal host? I be...
Hello, I'm relatively new to Cisco firewalls and I'm needing some help. I have created two networks, one for each of my LANs. I need to set the DNS to be custom on one of the networks. I can create a DHCP scope, but I can't see where I can set the cu...
@Alan Ng'ethe wrote:For me its mainly simplicity; one can configure translations as part of network object definitions, which are added tothe configuration. Auto NAT reduces configuration complexity when only one translation policy is required for a ...
I think I may have done a poor job explaining my situation. My apologies. We normally deploy Meraki MX firewalls. With those, we can easily accomplish what I am trying to do. ISP puts the modem into multihoming and then we just create a 1:1 NAT that ...