Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone
I am setting up the PBR in a cisco 3750. The route-map is ok, I even triggered a SLA and a track object, but the interface "ip policy" command is not being retained in running-config. The SDM profile is set up as routing already:
BR-...
Hello Everyone
I am trying to setup one Access Point in PI 2.2. Thia AP is installed at 16 feet from the floor but I can't configure it in more than 10 feet.
Does anyone have the same problem or know how to fix it up?
Thankls
Hi, no you can't
Index 1 Feature: lanbase Period left: 0 minute 0 second
There is you period left of lanbase license. there is not.
It just says that your hardware is capable to run a lanbase software. To make it happen, you can buy a la...
The VLAN configuration is written in the vlan.dat file. But the VLAN interface membership configuration stays on hte Running/Startup config. So when you delete the VLAN, the interface continues attached to the old VLAN. So, unfortunately, you need to...
I can see two mistakes in your set up.
1 - Router and modem interconnected interfaces are in different subnets. (192.168.2.0/24 ans 192.168.12.0/24).
2 - Probably the modem does not have a route back to the network 10.0.0.0.
If you are trying to N...
I thins it's related to the private-VLAN in Cisco switches.
With this feature, you can chose what interface can communicate to what interface inside the same VLAN. This is mainly used by service-providers for security reason(sometime in a shared medi...
