Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,
I have a router 4321 running iWAN and PfRv3 with two internet links of 30MB/s. The question is... is there a way to balance the traffic when one of link hit 100% utilization? (the egress traffic change to another link less used)
Thank yo...
"You're asking for the second link to only handle traffic in excess of the first link when it hits 100%?"
I meant when any link hit 100% the traffic change to another link less used. I would say that the trigger would be the when hit 100% in any one....
Hello!
This action worked for me when using authentication with PSK (WPA2 + AES). Devices not authenticating when this option "Flexconnect Local Auth" is disable. When enabled its worked immediately.
WLC 5508 - 8.5.171.0
AP 1800 in FlexConnect
Device...
I saw that AP dont received return from WLC, try to static config and after that put here the output "show capwap ip config". capwap ap ip address x.x.x.x x.x.x.xcapwap ap ip default-gateway x.x.x.xcapwap ap controller ip address x.x.x.xshow capwap ...
Hi buddy, Check the WLC9800 "Troubleshooting > Radioactive Tracing" the see AP join issues and also check the discover and join process via AP console.https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/21394...
