Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
http://www.cisco.com/c/en/us/td/docs/routers/access/4400/troubleshooting/memorytroubleshooting/isr4000_mem.html
As per the above mentioned document, show platform software status control-processor brief is having following output.
Router# show plat...
System returned to ROM by error - an unknown failure, PC 0x60C37964 at 13:03:34 IST Thu Jun 30 2016
Current Image : c1841-advipservicesk9-mz.124-4.XC7.bin
Planning to upgrade to c1841-ipbasek9-mz.124-22.YB2.bin.
Is crypto is supported in this vers...
There is a common understanding that OSPF operates at Layer 3. However, as per wikipedia, it operates at Link Layer i.e., Layer 2.
" OSPF multicast IP packets never traverse IP routers (never traverse Broadcast Domains), they never travel more than...
As per my knowledge, when an update is sent after adding a new network, the receiving router will also update that back in the same interface with higher metrics. For example, orinating router set scaled delay to 1 (just as a number), neighbor may se...
I agree. And I was also believed this only. But when I captured using Wireshark in a Layer 2 environment, I am able to see OSPF packets. That is what Wikipedia is trying to say. Then, is Wikipedia is right? or its a contradiction?
