Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've noticed there are Meraki commands that can provide lists of network devices; for example, all switches, APs, or all Meraki devices in a network or organization. However, some commands specific to switches (get switch port statuses) require the s...
go to interfacepower inline autothat will turn it back onexample of one I just did:
IDF_SW2.1(config-if)#int g4/0/41
IDF_SW2.1(config-if)#power inline never
IDF_SW2.1(config-if)#power inline auto
I read this in an ebook:Although subnet masks are displayed as dotted decimals, the format can be changed on Cisco routers to bit count or hex with the 'ip netmask-format bit' command... Router# terminal ip netmask-format ?bit-count Display ...
